Home Improvement Information

Removing Your Old Sliding Glass Door


Last week I explained how to measure your existing sliding glass door so you can order the vinyl replacement door. This week I am going to go over the steps required to remove the old sliding door before installing the new door.

First, you have to remove the sliding panel and the stationary panel. The vast majority of doors out there have the sliding panel on the inside half of the track, and the stationary panel is on the outside. Whatever the case in your particular door, the outside panel has to come out first. To remove the fixed panel, you need to remove the sill cap that snaps into the bottom track and runs from the fixed panel to the side jamb where the sliding panel locks. Force a screwdriver into the crease and pry the cap up. Then, look for screws on the inside side jamb holding the fixed panel in place. These screws prevent someone from prying up the sill cap and pulling out the fixed panel in order to gain entry into the home. In addition to the side jamb, be sure to check across the top header and bottom track for screws there as well. Once all the screws have been removed, you need to pull the fixed panel away from the side jamb. You can start by simply grabbing the side rail of the fixed panel and pulling as hard as you can. If you're lucky, the panel will pop free. Then you can lift the panel up as far as it will go into the top channel and swing the bottom away from the track, and remove the panel.

Now, I said "if you're lucky", because in most cases the panel will be stuck in the side jamb, the bottom track, or both. Usually, you're going to have to use a pry bar to loosen the fixed panel before it will slide out of the side jamb. Once the fixed panel is out, removal of the sliding panel is usually easier. Just lift up and swing the bottom away from the track, then remove the panel. Sometimes the bottom rollers will prevent the bottom from swinging out of the track. If that's the case, you will need to find the roller adjustment hole in the bottom corners of the sliding panel. Put a screwdriver into this hole and turn the screw counterclockwise to bring the roller as far up into the bottom of the sliding panel as possible. This should allow the slider to come out.

Now, you want to remove all the screws from the side jambs, top header, and bottom track. Then, take a pry bar and get it under the bottom track about in the center. Pry up until the track is separated from the floor. The next step will depend on whether your old frame is nailed to the house frame, or simply screwed in. If it's screwed in, then the frame should now be loose in the opening, since you removed all of the screws. You just need to remove whatever inside trim there might be around the door frame. This type of frame should come out. If your door is nailed to the house frame, you will have to do a bit more work. Use a hacksaw to cut the track in half, approximately in the center. Start with either half and raise the cut piece up towards the side jamb until the the track piece separates from the side jamb. Do the same thing to the other half.

So, now you have to remove the side jambs. You want to do this without damaging the exterior material that surrounds the door frame. Take a heavy chisel and pound it into the crack between the frame and exterior material, whether it's stucco, siding, etc. Start at the bottom 6 inches first. What you are trying to do is pull the nail fin away from the nails holding it in place. So, once the chisel is pounded through the metal frame, pry away from the side wall. The heavier and longer the chisel, the more leverage you will have. You will hear the frame "pop" free of the nail. There will be several nails holding each jamb in place, so you want to start at the bottom and work your way to the top corner. Once you get the bottom third loose, many times you can grab the jamb with both hands and pull the rest of the nails free as you go up. When you get to the top corner, work the jamb free. Do both jambs, then do the top. Sometimes the top has no nails, or just one in the center, so it will come down pretty easily. Be sure to wear safety glasses and a dust mask when doing this job, especially when removing the top header.

At this point you are ready to install the new door. The installation procedure is slightly different, depending on whether you're installing a retrofit style frame or a replacement frame. We will discuss both procedures next week.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows


MORE RESOURCES:

Perth Zoo's elephants enjoy $5m home improvement
NEWS.com.au, Australia - 13 hours ago
PERTH Zoo's three elephants are now enjoying a $5m expansion to their South Perth residence. The newly completed $5million elephant exhibit redevelopment at ...


MARC offers home improvement loans
Leavenworth Times, KS - 1 hour ago
By Tim Linn The Leavenworth County Commission debated a proposal from the Mid-America Regional Council on Thursday that would provide homeowners in the ...


Newsday

9 home improvement projects for '09
Newsday, NY - 21 hours ago
Home improvement experts attribute it to the fact that these projects tend to be relatively small (on Long Island, $300 to $900 for a replacement window, ...


Home improvement Q&A: Proper care and bleeding of a radiator heat ...
News & Observer, NC - Jan 8, 2009
By ALAN J. HEAVENS - The Philadelphia Inquirer Question: Do know anything about radiators and boilers for the home? I'm not sure about proper bleeding and ...


9 home-improvement projects for 2009
Seattle Times, United States - Jan 3, 2009
A look at what home projects will allow folks to live better now and make the house more saleable later. By Karen Klages A bathroom remodel may make your ...


Saving energy & $$
Ukiah Daily Journal, CA - 7 hours ago
However, if you are concerned about your wallet, how do you save money on your energy bills without emptying your savings on home improvement projects? ...


Do thorough research before signing a home improvement contract
Detroit Free Press, United States - Jan 4, 2009
... the economy on shaky ground, it's more important than ever for homeowners to carefully screen the contractors they hire for home improvement projects. ...


BobVila.com

New Year's Home Improvement Resolutions
BobVila.com, MA - Jan 5, 2009
I dug headfirst into the home improvement projects I had left over from last year. Late fall was consumed with the downstairs bathroom renovation in which ...
How to save money on your home improvement project YourHub.com
all 2 news articles


Home design depression
Boston Globe, United States - Jan 7, 2009
The sad truth is, if I had an IV drip of Diet Pepsi I could spend all weekend watching HGTV, or any of the home improvement shows on the DIY Network, ...


Plan ahead to save money on energy, home improvement
Staunton News Leader, VA - Jan 3, 2009
And, thanks to a number of plastic storm window kits available at area hardware and home improvement stores, putting plastic over your windows is easier ...

Home-Improvement - Google News

home | site map
© 2006